How much accessory work is too much? The answer is not a set count from a book. It is the number of top-set reps your accessories take from your next heavy session, and that number is different for every lifter and every exercise. A simple log makes it visible.
This article covers what to write down, how to turn it into a cost for each accessory, how to compare that cost with what the accessory is supposed to build, and how to decide what to keep, trim or swap. It prices volume. If you want to choose accessories by how your joints felt, the joint-feel cycle article covers that approach.
Why “I felt wrecked” is not a number you can plan with
After a long accessory day, “I felt wrecked” tells you something happened. It does not tell you which exercise did it, how much it cost, or whether the cost was worth paying. Soreness is also a poor stand-in for fatigue. Some accessories leave you sore and cost the next heavy session nothing, and others leave you feeling fine and quietly take reps off your squat.
A number lets you compare. If one accessory block costs your next top set a rep and another costs two, you can rank them, and you can weigh each against what it gives back. Without a number, the exercise you remember most vividly gets blamed, and that is often not the one doing the damage.
The method has a limit. Your next top set is also affected by sleep, food, stress and how the main-lift program itself is progressing. That is why the log works over weeks and not from one session, and why you change one accessory at a time.
The three things worth logging
Keep the log small enough that you will actually fill it in. Three entries per heavy session are enough.
- Next-session top set. Write the load and the reps of your top set on the next heavy day for that lift. If you work to a fixed load, reps are the cleanest measure. If your program moves the load around, record the load you hit at the planned effort. Add a one-word note on bar speed (fast, normal, slow) if you want a third signal.
- Reps left in reserve. At the end of that top set, write how many more clean reps you think you had. Honest reps in reserve catch the cases where the rep count held up but only because you ground it out.
- Session effort. Rate the whole session from 1 to 10 once you have finished. This catches fatigue that does not show in the top set, such as back-off sets that went badly.
Beside these, record what you did in the days before: which accessories, how many sets, how many reps, and which day. Do this for the accessory days between your heavy sessions, and credit the cost to the heavy session that follows them.

Build a fatigue cost for each accessory
The fatigue cost of an accessory is the reps it takes from your next main-lift top set. To work it out you need a baseline: your top-set reps at a given load after a week where that accessory was left out or cut to a minimal dose. Then:
Cost = baseline reps minus reps after the accessory block.
If your baseline is 5 reps and you got 4 after the accessory block, the cost is 1 rep. If you also finished the top set with zero reps in reserve where the baseline week had one or two, count that as extra cost even though the rep total looks the same.
Before you trust any single cost, find your normal variation. Look at your top sets across a few weeks where nothing changed. If your reps move by a rep between weeks for no obvious reason, then a cost of one rep is not yet a finding. Only costs bigger than your usual swing count.
Change one accessory at a time. If you add a new row variation, a new hinge and extra leg work in the same week and your squat drops, the log cannot tell you which one did it. Alternating two options across weeks, while keeping everything else the same, gives the cleanest comparison.
A related question is what is still tired on a given day, and that decides which kind of session to run. The article on choosing a kettlebell or barbell complex by what is still tired covers the symptom side. The cost log here covers the volume side.
Separate the cost from the payoff
A cost means nothing alone. An accessory that takes a rep off your next squat is fine if it fixes the thing that was holding your squat back, and a waste if it does nothing you can point to.
For each accessory, write one sentence stating what it is supposed to do before you start logging. Be specific about the target:
- “Hold the bar position at the bottom of the squat without my upper back rounding.”
- “Raise my pause bench off the chest.”
- “Keep my grip from failing on deadlift back-off sets.”
Then pick one way to check whether it is working. That might be the accessory’s own progress (more reps at the same load, or the same reps at a higher load), a rating of a specific position from video, or a change in a weak point of the main lift. Check it at the same times you review the cost.
The payoff is often harder to see than the cost. That is the reason to define it beforehand. If you only look at the payoff afterwards, you will find some benefit for almost any accessory, because you were looking for one.
Worked example: two back accessories before a heavy squat day
The numbers below are made up to show the arithmetic. They are not data from any real lifter and not a target for yours.
A lifter squats heavy on Monday and does back accessories on Friday. The goal is a more stable upper back in the bottom of the squat. Two candidates are 4 sets of barbell rows and 4 sets of chest-supported rows. The baseline, from a week with no back accessories, is a Monday top set of 5 reps at the working load with 1 rep in reserve.

The lifter alternates the two across four weeks, changing nothing else:
Week | Friday accessory | Monday top set | Reps in reserve | Session effort |
|---|---|---|---|---|
1 | Barbell rows | 4 reps | 0 | 9 |
2 | Chest-supported rows | 5 reps | 1 | 7 |
3 | Barbell rows | 3 reps | 0 | 9 |
4 | Chest-supported rows | 5 reps | 1 | 7 |
Barbell rows averaged 3.5 reps, so the cost is 1.5 reps from the baseline of 5. Chest-supported rows matched the baseline, so the cost is about zero. Barbell row weeks also finished with no reps in reserve and a higher session effort, which supports the same reading.
Next, the payoff. The lifter rated upper-back position in the bottom of the squat on video, from 1 to 5, each week. The ratings were similar under both options, and row loads progressed at about the same rate. Barbell rows gave no extra payoff for their higher cost, so the lifter swaps them for chest-supported rows. This works because the same payoff came at a much lower cost.
The pattern in the example can also run the other way. If barbell rows had clearly improved the position rating and the cost had been the same, the decision would be to trim them, not drop them.
Keep, trim or swap: decision rules after four weeks
Four weeks gives you a few data points per accessory, which is thin but usable if you read it carefully. Set your thresholds before you look at the numbers, using your own normal variation as the line between a real cost and noise.

For each accessory, answer two questions: is the cost above your normal swing, and is the payoff visible?
- Keep when the cost is within your normal variation and the payoff is visible. Leave it alone, and do not add sets just because it is cheap.
- Trim when the cost is above your normal variation and the payoff is visible. The accessory is working but is priced too high at this volume. Cut the sets by a third to a half, or move it further from the heavy session, and log it again for another four weeks.
- Swap when the cost is above your normal variation and the payoff is not visible, or when a cheaper exercise can do the same job. Replace it with an option aimed at the same target and start the log again for the new one.
- Drop when the cost is within normal variation but there is no payoff. It is not hurting you, but it is using time and effort you could use elsewhere.
If the numbers are unclear, treat the result as a tie and gather four more weeks. Do not change two accessories at once to resolve it, as that rebuilds the problem the log is meant to remove.
There is also a ceiling, which answers the opening question for you personally. If the total cost across all your accessories is more than your top set can absorb, you have found your own limit. The fix is to trim the accessory with the worst cost-to-payoff ratio first, not to cut everything equally.
Where a low-cost kettlebell accessory block fits when your numbers say to trim
Trimming leaves a gap. If you cut four sets of a costly accessory to two, you may still want conditioning, grip work or some posterior-chain volume in the session. A kettlebell block is one way to fill that gap, and it goes into the log like any other accessory: write down what it is for, run it for four weeks, and price it by what it does to your next heavy day.

Whether a kettlebell block is cheap for you is a question for your own numbers. It may cost you nothing at one volume and a rep at another. Place it after your trimmed accessories, keep it short, and keep its day separate from the heavy session so the cost stays attributable. The article on two jobs for a kettlebell flow in a powerlifting split shows where such a block can sit in a week.
If you want a kettlebell accessory option to test against your log, you can look at kettlebell.monster. Affiliate disclosure: this is a referral link, and I may earn a commission if you buy through it.